I am building the following system.
1. Multiplus II 3000
2. VenusGX
3. MPPT 150/100
4. 2x pylontech us3000’s
I first powered the Venus. Connected it to wifi and updated it. All good
Then powered the MPPT. Updated it and connected it to the venus. All good
Then built the correct cable for the batteries. Connected them and set them up in venus. Venus recognizes them. All good
Then put dc power to the MP II. I can see the Multi on the venus but cant get the mk3 to recognise it. The VE config3 recognises the MK 3 but not the multi. It is a normal UTP cable right? From the mk3 to the multi?
I tried this in many configurations. As in directly to multi with no venus. And with venus connected but no go... any ideas? Byw. Venus sees the multi just fine with same cable that the mk3 does not see it with...