hello i have bought a Multiplus 1600 VA and the leds are always off
there is a correct entry voltage but no AC voltage and no green led on
the fuse seems to be ok
asked
multiplus 1600VA green inverter led is off
yes of course 2 12V batteries and a victron mmpt with float led on
HMmmm.
If the multi has 12 (24?)v at its input terminals, and is switched on, it should work / green led.
Disconnect any thing plugged into the VE bus ports.
Other than checking you have 27v at both sides if the fuse, I am out of ideas.
the fuse inside the victron ? there are no voltage when the swith is on
the fuse inside the victron ? there are no voltage when the swith is on
No voltage either side of the fuse??
You seem to have a bad connection between the battery and multiplus.
@philippe GONIN if your fuse is blown, you will have 27v one side and 0v the other side.
0v each side seems to be a problem before the fuse.
Check your wiring between the battery and inverter, on both neg and pos wiring.
Is the MultiPlus switched to ON, not charger-only?
Is the wire bridge in the remote connection? Any remote panels connected? Anything else that could control the MultiPlus?
DC voltage is at the battery terminals of the MultiPlus?
yes the wire bridge is present
leds are off with or without panels
the victronconnect app and voltmeter mesure show 27.4 V at the DC entry of the Multiplus
VictronConnect app? So you have a VE.Bus Smart Dongle?
Is the Multi switched to ON in the app?
What other components do you have?
