This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I am considering buying a MultiPlus II 2x120V for my Grand Design 337RLS Fifth Wheeler, which has 50amp electrical.
The MultiPlus II manual indicates AC-out-1 can supply up to 75A using PowerShare. Is there a configuration setting on the MultiPlus to limit the AC-out-1 to 50A per leg during a PowerShare scenario? My panel is limited to a 50A main.
The 50-amp per leg limit is correct. I think the "PowerAssist" you're referring to is just for short periods of use drawing from the battery.
There is no way to throttle back power assist. It adds available inverter power to incoming shore power. So if you have 50 amps of shore power you get 25 additional amps on leg 1 from the inverter for a total of 75 amps. L2 is not connected to the inverter when 120/240 mains power is present so it's a max of 50 amps out.
That said, you don't need to use that additional 25 amps. Your distribution panel is probably fitted with dual 50 amp mains breakers which will prevent drawing more than 50 amps per leg (at least continuously).
While you can use power assist with the full 50 amps of shore power, that is not the only scenario where it is useful. For example, when shore power is limited, e.g., when you are running the RV on a 120 volt 20 amp receptacle. You'd set the input current limit to 20 amps then if the loads draw more than that, the inverter will kick in and supply up to 25 amps of additional power. Of course this comes from the batteries so you don't get this assist indefinitely.
