This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Interfacing-with-VE-Bus-products-MK2-Protocol-3.12.pdf
Will have the answers that you need. Your question does not sat what you are trying to do, or give any detail of your setup which would make it easier to answer.
Actually we want to connect easy solar 24|3000|70-50 inverter with third party monitoring. we are not able to understand that which parameter is there to send the command to the inverter and which parameter there to know when and how to send the command. This quires is related to GX modbus TCP resister mapping.
you can MONITOR the inverter over the MODBUS map in the GX device, this is done by sending a normal Modbus TCP/IP command to the GX's IP address. Initially you also have to enable the modbus access in the setup menu. how often you send the requests is up to you, but faster than 1 sec is probably not recommended. There is a document: "CCGX-Modbus-TCP-register-list-2.60" that gives the register addresses and their functions/units.
We are doing but not able to understand this following point.
We are doing but not able to understand this following point.
46 People are following this question.