This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Due to Space limitations i have to install max. the Multiplus C 12/1600. I use the diyBMS, a RaspberryPi with Venus OS some SmartSolars and a SmartShunt.
I have seen, that there is a way to connect 2-Signal BMS to a Multiplus 3000 and bigger. As the 1600 does not have a AUX input, can i use another device? e.g. Temp sensor of the Multiplus for OVP and the Aux input of the SmartShunt? Or ist there an alternative way of connecting my BMS to the Multiplus?
You could do is to use this cable:
https://www.victronenergy.com/cables/cable-for-smart-bms-cl-12-100-multiplus
and set the 2-signal BMS assistant to "BMS has one contact for high and low"
Or you use the low cell signal from you BMS with the assistant and with the high cell signal from the BMS you cut-off the AC IN with a relay.
Or you use the low cell signal to switch a relay that is connected to the remote switch of the Multi to switch it from ON to Charger-only.
@Matthias Lange - DE, found the Solution!
Thanks to:
https://diysolarforum.com/resources/victron-two-signal-bms-assistant-for-multiplus-and-quatro-inverter-chargers.61/
Three very interesting ideas. Thanks!
I have checked the installation instruction of the the proposed cable. But somehow, i have missed which input it uses. Does it uses the "H" "Remote switch"? Can i use the RaspberryPi with Venus OS at the same time?
If i use this cable, could i not use "D" "Temperature sensor" as the second input? The temperature will be provided anyway by the SmartShunt.
The manual says to connect it to the remote switch but if I remember correctly I also used it successfully at the T-sense input and 2-signal BMS assistant.
There are some good hints, sadly the thread is dead since dec. 2020
https://community.victronenergy.com/questions/59581/vebus-bms-and-multiplus-remote-switch-off-off-mult.html
