This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Currently I have a Magnum 120/240 4kw 24V inverter + a generator which is running in 240V (though it can output 120V as well).
I have a deep well water pump 240V
I'm upgrading to 48V. Looking into using a Quattro inverter. Since there is no 120/240V Quattro, what would you recommend in my case to get both 120V and 240V?
Should I get 2 x 120V Quattros and connect them in parallel?
Or probably a 240V Quattro + transformer?
Many thanks for your assistance!
In my opinion, the best solution is to run two Quatros in split-phase mode. That gives you two 120 volt legs with 240 between them, like you'd find in a home electrical system. Your generator would then connect to the split-phase input to the Quatro pair in 120/240 mode.
You could also run a single 120 volt Quatro then create your split-phase output via an autotransformer.
Or a 230 volt Quatro adjusted for 240 then into the same autotransformer. Your generator would output 240 volts (with no neutral connection) into the Quatro.
Victron sells 32 (7600 VA) and 100 amp (24000 VA) autotransformers.
Thanks a lot Kevin. Also as I understand transformers cause some power loses, which is another plus for 2 Quattros in parallel
...generator would then connect to the split-phase input to the Quatro pair in 120/240 mode.
Sorry if it is a dumb question, does it mean I connect the generator to both Quattros?
Appreciate all your help!
Using a single, Quatro and a transformer might be a little less efficient but would save you money.
If you don't also have a grid, a Multiplus might be less expensive. It lacks a second AC input, but two Multis you can produce 6 KVA split-phase. Two Multi Compacts would produce 4 KVA split-phase. Quatro would be indicated if you need more power than that.
Thank you very much again Kevin for your valuable input.
I didn't find a Multiplus 48V 5KVA 120V, does it exist?
I have an off-grid house, there is power down the road but I will definitely stay off-grid with my setup.
My plan is to go with 2 x Quattro 48/5000/70 120V, which will give me 10KVA. I also know each Quattro can handle up to 10KVA peak, so even more room to play here.
I also wanted to be able to charge an electric vehicle later, even at lower amps, what are your thoughts on capabilities of 2 x Quattro 48/5000 for this purpose?
I think the beauty here is I will be able to add more Quattros later if needed.
