I am running firmware v485, and my EasyPlus is attached to a 200Ah LiFeP04 battery with on board BMS.
I am testing the system in lab before final installation and I noticed this behaviour.
I lightly discharge the battery using the inverter, let's say to 13.09V
The I attach the mains and the charging starts. First the bulk phase kicks in at 50A
Then it soon enter the absorption phase and current decreases:
Suddenly the Inverter and Charger switches off without any warning or errors. It comes back online after few seconds.
It then enter again insto absorption phase where it stays permanently at 98% drawing 0A
I have tried the above with and without AC loads connected but it's alway the same. The EasyPlus kind of "restart" during the current ramp down of the absorption charge and reconnect staying in absorption at 0A and 98% forever.
Any idea?
Thanks!