Hello, i want to install a few Victron products in my Worktruck.
I have a question about a Cerbo GX, a temperature Sensor and the Cyrix Li-Ct Relay.
I want to protect my 24V 110A Alternator from overheating.
Target:
If the temperature in the Alternator is too high, the Cyrix Relay should open and diconnect Generator/Batterybank 1 (AGM) from Batterybank 2 (Lifepo4)
And connect again when the temperature is cool down.
If this possible with an analog input form a additional temperature sensor wich is connected to the Cerbo GX and a programmable digital output of the Cerbo GX to the Cyrix?
(The BMS can disconnect and connect the Cyrix as well, thats the reason it should work)
A DC/DC Bosster or a temperatur controlled Alternator is the right thing for that, but i can´t find a bidirectional DC/DC Booster and the Balmar Alternator is too expensive.
Why i need a bidirectional solution?I have two power sources.
A Charger when i´m on the construction side and DC-Alternator when i´m on the way to work or home.
To charge i use a Skylla-i 80A for the Lifepo4.
2x 24V 200Ah Batteries parallel
My Truck have 2x 12V 260Ah AGM in series with a standart Alternator.
Or did you have another idea?
Best regards Robert