First-time poster -
I just installed a SmartShunt monitor inside a waterproof box that I attached to the outside battery box of my new Airstream trailer. Horrendously poor BT signal. I have to be in direct line-of-sight if outside the trailer and literally within 3 feet of it if I'm inside the trailer to connect via the app. This problem is well document on the forum and I accept that the Airstream's aluminum frame presents some unique challenges. My solution is to add a BT dongle to the shunt with the dongle's head inside the trailer. I have another dongle connected to my 150/35 MPPT and it gives great BT reception both inside and outside of the Airstream so I'm hoping this is solve my problem with the Shunt.
However...... I just found out that the dongle cable is about six inches too short to reach the box if the dongle head is inside the trailer. Questions for this group:
1. I see that Victron sells various sizes of VE.Direct cables but all have female connectors on each end. Does Victron sell or recommend a male-to-male adapter that I could use to mate the dongle's cable to a short, 1 ft. VE.Direct cable?
2. I found a JST-PH 2.0mm 4 Pin Connector Kit, Male/Female with Pins online. Any thoughts if the male-to-male part would properly join these cables?
3. Thoughts on any other solution to this would be appreciated.
Thanks
Chris