Can someone help me with the correct app setting for a lead crystal battery? It's 100AH. I can not find any info on these batteries in the instructions.
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Can someone help me with the correct app setting for a lead crystal battery? It's 100AH. I can not find any info on these batteries in the instructions.
find the specifications of your batteries and use the values from it, you didn't state what brand / type you use, so we cannot google it for you.
Hi Boekel
Below is the data sheet link.
https://leadcrystalbatteries.com/wp-content/uploads/2018/11/6_CNFT-100-1806-1.pdf?x26179
Ok. so have you set all values on your chargers according to the datasheet? (I don't know what else is in your system)
then to start (you can fine tune if needed) set 'charged voltage' a little bit (0,1v) below absorbtion (at the maximum temperature you normally reach), and tail current slightly above the current you'd end absorbtion with.
I have got the bmv-712 working, but am unsure as to what setting still. This is what I have set it up to.
I also have a Redarc bcdc1240 in the system that managers the charge. This system is for my dual battery in my vehicle.
Additional resources still need to be added for this topic
5 People are following this question.