This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi community. I am using a 100/50 smartsolar mppt controller and 2 rwo 370 w and Voc 46.9 V VOC panels connected in series. Those two panels have a total VOC voltage of 93,80 V. I have got a 7% margin to the Mppt limit input. Do you think it is safe on my controller?
Thank you
Remember that those ratings are at 25˚C. If it gets colder then the Voc will be higher.
I don't know which PV modules you are using, but using typical values, your Voc wil go above 50V per module at 15˚C (more than 100V for the series string) which will exceed the 100V limit of your controller.
What is your battery Voltage? If it is 12V or 24V then you could connect the two PV modules in parallel and then you would keep well below the 100V limit.
Thanks for your help. I have read the manual many times and It says that if the input power (voltage) is higher than the limit (100 volts) it will limit it to those numbers (100 volts). We all know that some solar controllers and other itens have a certain margin/tolerance on their limits. My question is:will it limit the input to 100 volts or will it damage it (the mppt 100/50 smartsolar controller)?
Thanks for your answer. As you can see from the controller manual, it only says that if more PV power is connected, the controller will limit input power (to 100 volts). It does not mention damaging or shutting down. Thanks 16241402890252877164893189742412.jpg
If the input power in Watts is higher than the MPPT controller rating in Watts it will limit the power, voltage is not power, you are confusing different things.
