Victron multiplus 3,000 watt 12v inverter/charger
300 amps hours of battleborn Lithium batteries
850 watts of solar panels.
50/100 smart solar controller.
Two 15,000 btu A/C units with a microair easy start on the livingroom unit.
Honda EU2200 generator
Current limiting set to 17.5 amps
Scenerio #1
Battery bank at 100% in float or absorbtion mode
Generator running
Multiplus set to on
Turn on Livingroom A/C unit
A/C runs fine and will have a little extra power to run a few lights, TV with a few amps going in the battery bank
Scenerio #2
Same as above but battery bank is just less then 100%
Inverter charger goes into bulk mode with 120 amps going in the battery bank.
A/C starts up and runs but multiplus is in assist mode and battery bank is draining fast.
Is there a setting that I can configure to not have this happen? Can I choose to give priority to the ac load and not the charger?
If I set it to inverter only there is no power comming in on the grid and the A/C is running only on battery.
I know that I could let the battery bank fully charge before I run the A/C but on a very hot day after a long drive and your RV is 102° F inside, you want to cool off as soon as possible.
Thanks
Lou Cetrangelo