This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
First install!
My Smart Solar MPPT 75/15 is not loading my LiFeP04 battery. I have a 190W solar panel and the readings directly taken from the wire endings said ~25 V. But when I connect the cables into the Victron MPPT device (I checked polarity) did nothing happend and the battery didn't load. Battery tension was at 13,4v
Tension from the Solar on the app said 0 V and 0 W.
Measuring it with a mulimeter on the screws gave me 0,8V.
I have installed the latest firmware.
It would seem that you have connected your PV array in reverse polarity to your mppt.
I will recheck the polarity through the whole chain.
Could the issue also be related to the point that I have placed the MPPT horizontal instead vertically?
Yeah heat can be an issue. The 75/15 has no fins on the back so not so much of an issue i can see for the orientation being a problem.
Ours works hard and in a warm environment so we did mount it on a heat sync block to help.
I have the same problem, except that it worked for a while, but suddenly this status.
Battery 12.3V and solar 19V, and I'm certain about the connections.
Shouldn't the MPPT show correct solar voltage if not loading?
Your array needs to be 5v above battery voltage to begin charging.
Yours is not quite there.
https://www.victronenergy.com/live/drafts:mppt_faq#q6the_solar_charger_is_not_working
Hi Alexandra,
19-12.3=6.7 so well above the 5V limit.
And why is the MMPT not showing the current array voltage?
Does the MPPT loads the array even if it is not charging?
