I read through the other questions asked on this and couldn't find an answer. Hopefully this thread helps someone else.
The voltage on the app goes up and down depending on what I have plugged in so I'm pretty sure it's wired correctly but the Time remaining always says "Infinite", the consumed Ah never changes from 0, Power never changes from 0 and Current never changes either.
I charged the battery on my trailer by plugging in shore power, then gave it a full charge and then ran the "Synchronize SOC to 100%" and I also flipped the load shutoff switch and calibrated it to Zero Current.
I've double checked that the shunt is wired correctly, pictures attached.
I also removed the rock lights and the ground wire, neither changed anything.
Does anyone have any ideas? The hardware setup wasn't too bad but the app settings are insanely confusing. I've attached those as well.
Also these are my settings for the Marine Master DC24 (CCA @ 0 is 500), hope it might help someone, but I'm only about 30% confident the settings are right.