This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Skylla I permanently in storage mode.
Charges at about 25 amps at 24 when on it's own.
When Quattro is charging the Skylla does not charge at all. Its connected via VE Can and can be seen on the Cerbo. The rest of the system is 3x200 24volt A/h smart lithium in parallel with VE bus bms.
Need to have quattro and Skylla charging at full power to reduce run time of generator
The Skylla is set up for Lithium
I have the same issue. I use a Quattro 24V together with a Skylla-i to be able to load LiFePO4 batteries at 200A, but while the Quattro is in Bulk, the Skylla is in storage and is not outputting many amps. How can I have the Skylla in Bulk mode?
It seems the unit goes into "storage" when 27V are met. How to disable this behaviour?
Apparently I have the same problem. Did you ever find a solution?
Doing an internet search on Skylla firmware, I found a post that somebody tracked this issue down to the "Watch" function (setup item 30). Turning that "off" will solve the issue with the battery stuck in storage mode.
