This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have a 3600W isolation transformer. ITR040362041 HQ1542RV7P1
I am trying to confirm that in the water I should connect a wire from the PE input side of the circuit to the J34A male spade connector. There has been a lot of back and forth on the forum and I am trying to get a simple answer on this question. I assume I have to make up this wire myself. I would also appreciate any input on wire gauge for this bit.
Tom
Yes, from PE IN to J34A. All wires are included.
Matthias. Thank you for the information. I only had 3 wires when delivered. Two black female to female jumpers to configure for 115 volts and the yellow/green jumper for out of the water operation from 34A to 34. Any info on wire gauge for the in-water connection wire? The PE on my unit only has the input wire clamp with no "top" clamp as shown in the cartoon drawing included with the unit. In my unit, I would have to piggyback the 34A wire into the same opening as the PE wire for the input power cable.
Does that make sense?
Tom
