question

leverg avatar image
leverg asked

GX Tank 140 parallel with analog gauges

gx140.jpgHi Community.

I would like to know if it,s possible to use a tank GX 140 in combination with analog tank gauges in this case from Wema.

See schematic below.

cerbo gx
gx140.jpg (114.7 KiB)
5 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

misssaigon avatar image misssaigon commented ·
Just considering going along this route and would like feedback on your experience. I have WEMA tanks sensors (2 water, 2 fuel) and currently running these to analogue gauges. Considering installing a Cerbo GX and would like to connect tank levels but not at the expense of losing the gauge read outs, which are visible from the boat steering station. The Cerbo GX won't be.
0 Likes 0 ·
Show more comments
1 Answer
Matthias Lange - DE avatar image
Matthias Lange - DE answered ·

This sensor seems to be a resistor based one (0-190Ohm) and can be connected directly to a Cerbo.

The GX tank 140 is for sensors with 0-10V or 4-20mA.

But I can't say if a parallel connected gauge will influence the reading.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.