Hi All
Help please...
My Multiplus (EasyPlus Compact 12/1600/70) will not switch off when instructed to by the BMS (Smart BMS CL 12-100). My set up is as per below -
I am using the Cable for Smart BMS CL 12-100 to MultiPlus (PN: ASS070200100). I have tested the V output from the load and charge disconnect on the BMS - they are performing as expected (both normally high). But when the BMS changes to load or charge disconnect - the Multiplus stays on. The V on the cable becomes free floating, as expected, but makes no difference to the Multiplus.
I have connected the Cable as per instructions which states - "When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal."
From the Multiplus manual - I have plugged the cable in as per below - black to terminal 2 and red to terminal 3.
I am expecting the Multiplus to switch off when either load or charge disconnect become free floating - but the Multiplus stays on.
Any help / advice would be appreciated.
Thanks,
Tim