question

chris-ebsworth avatar image
chris-ebsworth asked

BMV-702 Main & AUX Battery Connections Transposed

Hi All

Marine system with shore power and 230A alternator

Quattro 12/5000/230/2 x 75

CCGX

BMV-702

4 x 150 AGM Main Batteries

1 x 100AH Starter Battery

I have discovered that since new 2 years ago the main battery bank sense wire is connected to B2 AUX input on the shunt and the AUX (Starter) battery sense wire is connected to the B1 input.

The CCGX battery monitor is set to Automatic which means that the BMV is selected by default.

So when running on batteries the CCGX displays the main bank current but the starter battery voltage.

So does this mean as I suspect that the charging algorithm is compromised??

I.E. when the shore line is re connected the main battery bank charges but according to the voltage of the starter battery??

I would be very grateful for your thoughts.


BMV Battery Monitor
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
JohnC avatar image
JohnC answered ·

Hi @Chris Ebsworth

IF you've enabled DVCC, then the shore power charge may have been compromised, but probably really only with the adaptive algorithms also enabled.

Maybe there's been some overcharging, and you may be able to detect something on the VRM graphs.

Without DVCC then there shouldn't be any effect, except perhaps some inaccuracy in the SOC readings. That may pass through to the kWh history in the BMV, and if you use that, then maybe time for a history reset.

Not much you can do about it now except fix it, move on, and hope for the best. And wonder why it took 2 years to spot it.. :)

4 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

chris-ebsworth avatar image chris-ebsworth commented ·

Hi John

Thank you for taking the time to answer. DVCC was not enabled however unfortunately all 4 batteries are quite swollen and their capacity reduced indicating that overcharging has occurred. I have since corrected the wiring and the displayed voltage now follows the 4 stages of Bulk, absorption, float and storage.

New batteries required I fear!!

Cheers

Chris


0 Likes 0 ·
chris-ebsworth avatar image chris-ebsworth commented ·

Hi John, I am getting conflicting information from the original installer which leads me to the nub of my question.

If the CCGX is set to display the Main Sense Voltage B1 on the BMV-702 is this the actual voltage that is used by the Quattro to control the battery charge??

This is the crucial question.

1617812298701.png



Cheers

Chris



0 Likes 0 ·
1617812298701.png (10.3 KiB)
Show more comments

Related Resources

Additional resources still need to be added for this topic