This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
As stated, from memory and towards the end of 2020, the ability to control a Multiplus 12/3000 via the GX Touch 50/Cerbo GX simply didnt exist.
Is this still the case, or has there been an update implemented that now allows this to occur? If so, does it also control current limit? Not that id want to adjust that anyway. And does it work with a Ve.Bus BMS installed?
The latest Cerbo firmware has the ability to change the input current limit on the Multiplus 12/3000. I believe it was v2.65~8 and above released in the last week or so.
This limitation applies only in combination with the VE.Bus BMS running Victron lithium batteries.
Since the last official FW update (released a few weeks ago) it is possible to control the input current. Switching the Multi/Quattro on/off is still not working.
That's such a pity. I dont really have the space do install a DMC. Do you know if there is anywhere to address this in a future update?
Are you sure about this? I believe I can switch of my Multiplus 800 (from 2013) via the VE. BUS on the Cerbo GX? Or is it not 100% off then? For sure I can switch from charger to inverter and as far as I can recall, also "off" is a possibility in the same menu? Or does it have to do with the model of the Multiplus?
I have hit the same issue. We did not get control panel as no space. We have Cerbro and gx touch. It uses same bus and control has menu that would appear to allow control, but I cant get multipoint to even power up.
just seams crazy
