This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have a Cerbo GX and Color GX screen. I want to add temperature sensors for my two batteries. 1. Does the sensor go on + or - terminal of battery? 2. Appears only one input on Cerbo and there are two wires from sensor? How do I connect wires to Cerbo unit. Thanks!
There are four temperature inputs on the Cerbo.
Here you can see I have connected just two temperature sensors to it on inputs 1 and 2:
On the other end, connect the sensor its self to the negative battery terminal.
This sensor lug does not need to be connected to anything of you are not measuring battery temperature. Leave it floating in mid air if you want to measure air temperature.
Thank you! This is exactly what I was looking for. Much appreciated.
Very helpful. How do I activate sensors. they are not showing up on color 50
Hi!
See the Settings -> I/O -> Analog inputs menu.
Have we not explained that in the manual?
Hello @cwvandy,
1. That temperature sensor is electrically isolated, so you can put it wherever you like, it doesn't even need to be on the terminal of the battery at all to function.
2. When making the connection you need to have the included terminal block of the Cerbo GX, then make the connection like this; with the red wire on the top and the black on the bottom.
@Guy Stewart (Victron Community Manager)
make the connection like this; with the red wire on the top and the black on the bottom
This should be added in Cerbo GX manual (chapter 2.9).
@Guy Stewart (Victron Community Manager)
And from the same Cerbo GX manual:
It is possible to adjust the temperature offset and scale.
These two settings are missing from my Cerbo GX (in FW 2.60 and also in FW 2.63).
My temperature sensor is measuring high, so I would need to use the offset to correct the displayed temperature value.
Edit
I found the answer to this: those two settings are only available if you have superuser permissions. Strange decision, but after enabling root access I could correct/offset the temperature value.Thanks much. Any advice on how to active sensor. Plugged into cerbo properly but does not show up on settings in color gx 50.
