question

adobe avatar image
adobe asked

Charge Controller showing low Voltage

img-7951.pngimg-7952.pngMy 100/50 has been working fine for over six months. Recently I noticed through the connect app that the batteries had failed to charge for a few days. Looking at the controller it was not charging even though it was sunny day. The PV voltage was showing at 12.6. I disconnect the solar inputs and measured 19.8 volts coming from the panels. reconnected the input to controller and back working. This has happened twice now and this time controller is saying 6v and I can't get it to charge. Any thoughts?

MPPT SmartSolarcharger
img-7951.png (302.8 KiB)
img-7952.png (323.6 KiB)
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Paul B avatar image
Paul B answered ·

if your panel voltage is only 5.57 volts then you have a issue with your panels ie a bad connection

also note that the panel voltage has to be 5v greater than battery voltage for the mppt to START charging.

as by the look you have 18 volt panels you would be better to connect these in series if you have more than one thus raising the open circuit voltage to 36 volts.



3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

adobe avatar image adobe commented ·

Thanks for comment Paul - What I'm wondering about is why if I disconnect and measure the voltage from the panels with multimeter its actually 19 volts. why is the app saying 6 volts? is it a fault with the solar controller?

0 Likes 0 ·
Show more comments

Related Resources

MPPT product page

VictronConnect manual

PWM or MPPT

MPPT calculator

MPPT codes

Chargers.

Additional resources still need to be added for this topic