This may have been asked before but in different language so I wasn't sure.
I want to have a multi or quatro fully off-grid system with let's sasy 20kW of panels feeding a few different buildings with AC 240V such as small house, shed, separate office, greenhouse etc.
Ideally on my Cerbo/Octo/whatever I'd love to see what is using what, or even when there is load (like if a building should be empty/off). I can't see an obvious way to separate AC loads but i think this would be a kiler feature and with current sensors should at least be hackable perhaps.
Is this possible to do such that it would display on a GX touch 50, or mobile dashboard/VRM?
Or does it need some serious coding via VenusOS or something else?
If a Victron employee reads this I think you should consider adding this feature as I can see it becoming increasinly common for offgrid solutions, even if it's just for house and shed, but 2+ would be ideal, and put a current senson on each circuit you have! Even in a house: lights/oven/power points/hot water heater etc. The data satistic uses are immense.
Thanks :)