I have 16 LifePO4 100ah batteries installed as 4 sets of 4 cabled to an inverter/charger. They are wired in series and then in parallel to the load. They‘re wired like your figure 9 in the quick installation.guide. (48 volt 400 amp total). My BMV-700 monitor is installed on one set of 4. Should the load/charge wire also be extended to the other 3 sets? As in your figure 9 all four sets are interconnected and all four sets have cabling to the inverter charger. Can I get an accurate reading on % of charge by having the monitor only attached to one set of four?