Good Day,
I am having the same issue that was reported in the "US3000 not shown on venus" thread. In my case I have a Multiplus-II GX (5k), thus it is a little more complicated to swap out and I'm hoping to resolve this without having to got that route.
I've read the aforementioned thread as well as other other related threads and I am pretty sure that I've got everything set correctly. Here are all the steps I have taken:
- Upgraded the firmware
- Set "CAN-bus profile: CAN-bus BMS (500 kbit/s)" (note that it was already set)
- Tried a different CAN-bus cable between the battery and the inverter (I have 2) and also tried flipping it around.
- Powered on and off the batteries
- Tried a single battery.
- Tried switching around the CAN terminator and the cable
Below are pictures and screen captures of my installation. Any help would be greatly appreaciated.
Thank You,
Ryan