I have just purchased LifePo4 victron smart batteries and a smart bms. Am I right in thinking that I use a non inverting remote cable to connect the bms to my cerbo gx and use dvcc mode to control the mppt.
also where does an Orion tr smart 12/12-30 go in this situation???
My thought was the Orion output goes to the ve+ post of the battery and the remote (h) connected to the bms, likewise the mppt output connects here also and is controlled via dvcc parameters.
I have a smart battery protect that I am putting between the ve+ post and my loads (bus bar) but see that it is one way hence the questions ref the chargers.
Hope this makes sense and thanks in advance for any constructive advice given.