Hello guys. Here are the details of my installation. Victron quattro 10000va, 8* 220AH ROLLS AGM batteries (two parallel banks), 5250Wp solar (5 strings on threes) sitting on a 150/85 bluesolar CAN MPPT. the installation if just 3 weeks old and just yesterday i noticed that no ac loads or input was displayed on the Ccgx. the inverter was off (toggle switch in on position). Upon removing the ve.bus cable from the inverter port , the float & inverter LEDs blink and cut out then the LOW battery alarm LED comes on. Surprisingly the bmv was showing a 100% SOC
I checked my wiring for any sign of reverse polarity on anything , intergrity of vebus cable , termination of can ports , correct orientation of BMV shunt and all seems fine . I disconnected the battery and checked the individual battery voltages and they ranged 13.91V to 14.03V. Top bank voltage was sitting on 55.3V & 55.4 for the bottom bank.
We had the pv charger kicking in the following morning and after some time the low battery alarm was cleared and the inverter LED came on, but still no show on the ac input and ac loads.
please assist on what could be happening to the system.