This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I bought a Victron Energy AGM Deep Cycle battery, 60Ah, for a small solar set-up.
I received the battery boxed, but there is not manual/leaflet with it.
I wanted to understand what to do about the first charge, and if it is needed?
In the solar system the solar controller is a Victron MPPT 75|10.
I can charge (if needed) the battery at home before installing it in my solar setup. But I only have an automotive charger I can use (CTEK 5.0).
How do I proceed?
Thanks in advance.
CTEK's are reasonable automatic chargers, Use the sealed/agm setting on the charger.
I would give it a charge and then install it in your set up like you would any new battery.
> Use the sealed/agm setting on the charger
Using that.
> I would give it a charge and then install
Yes, thanks!
I checked the voltage and the battery was at around 80% charge (guess it has been sitting for a while before the sale), so topping it up right now.
