This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi i just installed the ip67 charger 12v/7amp in my vehicle.
When the unit is in bulk or absorbtion modes, it does not keep the voltage or current steady, the unit audibly clicks on and off every 10 seconds or so and the current goes from 0 to 7 amps.
Charging 135ah agm battery. No load at the time.
I would suspect that its turning off from overload or over temp as its a 7 amp charger max , you are hitting its max limits and thus I suspect its turning off from overload or over temp. for a period and then back on to protect its self.
It doesnt shut down, it just clicks and drops/maxes out.
Surely it cant be overloading? Whats the point of it i it cant handle an average battery?
I don't know the answer, so we must start with
Troubleshooting
The first, easiest and most likely thing to check is the voltages at all relevant points.
Using a multimeter,
with EVERYTHING turned off, measure the voltage at the battery, and the terminal connections of the charger. Make sure there is no damage, and a good solid connection.
Then turn everything on, and repeat.
What are the voltages? Is there any unexpected variations, or are the voltages relatively close across the whole system?
Do those measured voltages match the voltages that are displayed in VictronConnect?
How is the charger wired up into the system, can you sketch a wiring diagram?
What are the LED's doing?
Are there any strange smells?
Is the unit warm to the touch at all?
