This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello
My Cerbo GX is connecting fine on WiFi without the GX touch 50 connected, but as soon I connect the GX touch 50 on it, the WiFi State goes from Disconnected to Connecting many times then Failure state
The WiFi signal strength is 76%
Cerbo firmware v2.60
Thank you for your help
I’m having the same issue . Wifi only connects when touch 50 is disconnected.
FWIW - still seeing this in 2.63. Cerbo was rock solid until I added the Touch, now it won't stay connected and generally doesn't reconnect on auto-reboot (has currently been down for ~48 hours). Will try the channel change then go to ethernet, but this is pretty disappointing.
Hey all, you’re all completely right: there is an issue with the Cerbo Wi-Fi when having the GX Touch connected.
And its related to harmonics. The harmonics of the hdmi signal to be precise.
Details here: https://community.victronenergy.com/questions/82877/cerbo-gx-wi-fi-issue-when-having-the-gx-touch-conn.html
My apologies for the trouble.
Ps; I dont like to accept my own answer, but I’ll do it here so that also others that find this through Google or otherwise get to the solution asap.
Hi,
in one of my installations, the exact opposite was happening.
It seems like, connecting the display is interacting with the WiFi signal.
But these things normally only happen, if the WiFi signal is weak in general where the CerboGX is installed.
In my case, I installed a WiFi repeater and all WiFi connection problems were gone.
Best Regards,
Markus
Thank you Markus, in my setup I have a strong WiFi signal, so in my case it‘s not a question of WiFi signal level but maybe interference from the display. I located the display as far I can go with the HDMI but it's the same result.
No answers from Victron on this issue. I added a Ethernet to Wi-Fi bridge rather than rip out the Cerbo after routing all the wires. It’s a shame Victron sells a product without testing it!
Same here. Anything from Victron???
In my circumstance, I manually changed the WiFi channel on my router to another one a couple of channels away. You could try this and see if it works for you, it could be some weird harmonic or interference in your environment.
Had exactly the same problem (the WiFi connection was available sometimes, but mostly failed). Thanks to the idea wkirby expressed above, changed the channel on the access point and the connection is stable every reboot, no issue at all. I think it can be indeed some sort of interference between the video chain and the WiFi, like the one observed in Raspberry Pi 4. If this is the case, then most probably we have no chance of Victron fixing this in software, unfortunately.
Any news to this?
now running cerbo v2.63. Had my Touch50 disconnected since last post. Wifi been stable. Plugged in touch 50 today.
imidiatly lost wifi.
been trying to restart cerbo a few times. Still no luck.
Disconnected Touch 50
Reboted cerbo.
works really great.
