Hey everyone,
I noticed with the recent ESS update the inclusion of a "new feed-in limiter". Woah-and-behold, there is a seeting in my CCGX for max watts feed-in!
Previously, I've just had a current limit set-up that when feed-in starts to exceed, the inverter drops ALL feed-in momentarily. What I wanted however was a more dynamic reduction of the MPPTs.
I was hoping this new setting would do just that, limit the incoming PV to reduce my feed-in such that it regulates at the set-point (if it is able to exceed it).
It seems however it does the same thing, just dropping all PV momentarily, then ramping back up. Cycling over and over.
Is this how this is intended to work? Certainly not ideal as I suspect the load fluctuations are putting unneeded stress on my setup.
For reference my system is as follows:
Quattro 10KVA (VE.Bus),
2x victron 150x45 MPPTs (VE.direct),
victron BMV (VE.direct i think),
CCGX.
Would be grateful for any advice! :)