Hey guys so I have 3 sunpower e-series solar panels on the roof of my van. They are all ran into a fusebox/combiner which when the fuses are shut sends the power generated from the panels to the mppt 150/35 charge controller. When I test the voltage from the panels on the line side of the fuses I get 72.9 volts for each panel. When I close the fuse completing the circuit to the charge controller and the batteries the voltage drops to 1.9 volts tested at the load side of the fuses and at the pv +/- terminals on the charge controller. I don't get any lights on the controller, and no bluetooth connectivity. I'm not sure what is going on, I have 1 panel on each side of the van on it's own charge controller. I messed up on one and had the pos./neg. wires swapped so I accidentally blew the fuse on the 100/20 charge controller for the drivers side panel, but that passenger side 100/20 controller works fine, I can connect via bluetooth, I have lights on the front everything functions properly. So, my other small controller is bad (need to replace a fuse) but the big controller for the roof panels seems to be drawing the voltage from the panels down a lot. What can cause this?
