question

jbleyl avatar image
jbleyl asked

Modifying existing installation to install Victron BMV-712

Hi all can you please check my diagram? I don’t want to mess this up. these are being swapped with BB lithium batteries. Thanks!


BMV Battery Monitor
3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Paul B avatar image Paul B commented ·

it would be much better if you did a line diagram so that we can all see what you are looking to achieve, as your picture is all over the place and you should be asking your electrician how to do this if you are not sure. and as you will be adding a BMS more than likely then this will complicate issues as well.

from your discriptions it looks like you are on the right track


0 Likes 0 ·
trip-tracks avatar image trip-tracks commented ·

Your sketch is correct

0 Likes 0 ·
Show more comments
2 Answers
Paul B avatar image
Paul B answered ·

This is the correct way to wire the shunt in


1599443076557.png (396.5 KiB)
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

jbleyl avatar image
jbleyl answered ·

Thank you for the reply, can you please look at my current setup that I attached with some notes? Am I on the right track- new at this

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.