This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
my Multi, MPPT, BMV and 4 x victron gel battery (in series) setup is generating frequent low battery voltage alarms as it dips beneath 49V (which is reportedly around 69% SOC according to the BMV).
The alarms clear almost immediately. I read some posts that suggested ESS can trigger this frequently as battery charge dips.
Is this normal for ESS and is there a way to make the alarms less frequent?
thanks
Hi @nickdb,
There are some suggestions in the ESS FAQ 5 - How can I suppress low battery warnings?
Hi. I read that faq but it is out of date.
The menu items have all changed and the defaults under “alarm setup” is now “alarm” anyway.
Hence why I posted the question.
I did change the automatic alarm rule on vrm to alarm only, will see if that helps.
Thanks
How are the alarms expressing themselves to you that you would like to change? E.g. emails, marks on the advanced tabs, audible sounds on the GX device?
I have the same issue and wanted to tweak the alarm a little. But when I try to close the VEC setup and upload the changed parameters I get an error "cannot save file"
Further I get a notification that the Assistants have a newer version (ESS in my case) and obediently downloaded the new version but every time I start VEC setup I get that notification again. It is not the reason for the file-safe error, I tried without updating ESS with the same result.
I probably can try to dig-up the RS485 interface, unscrew the lid and locally do the tweaking (in the shed at 2 degrees centigrade). But I got a little spoiled and would like some tips on this file-error.
