This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi Everyone,
I have 2 wind turbines to connect to my Victron mppt 100/20 controller.
My motors are dc 85w. So connection is just 2 wires.
Works well with one wind turbine. Straight forward connection with negative and positive.
My question is; can someone please tell me how to connect the 2 wind turbines in parallel to the controller?
please give detailed description of wiring and what is needed. If I need to use small diodes on the positive? Etc..
Please help!
Thx.
Hi,
connecting a wind turbine to a solar charge controller, without an additional braking (dump load) device can go wrong.
Imagine if your battery gets full, when stronger winds are blowing. The MPPT charger switches from Absorption to Float and so the output Voltage from the MPPT goes down. During that time the battery carries the load for a few seconds, as long as the Float Voltage is reached.
If the turbine is completely unloaded in stronger winds, it might get destroyed.
There are even more scenarios that can go wrong, connecting a second turbine in parallel to one controller, makes that list even longer.
I am sorry to disappoint you, but the good news are, that there might be a solution for that from Victron soon.
Best Regards,
Markus
Hi Markus,
Thanks for the info. Much appreciated.
I’m at the stage of connecting the wind turbines in parallel to the controller.
If you can please help with the wiring, as I later plan to have a dump load installed.
for now all I need is to not get the wiring wrong.
Perhaps you know of a web link to direct me.
thx again!
