This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have added the proper Victron temp probe to my Cerbo GX. It shows fine in the remote console, but it only shows as Celsius and I'm not able to find where to change that to Farenheit. Any suggestions?
I also can't figure out how to enable the temp probe on the "advanced" page to actually show a chart of the data, it's only showing in the device list now.
Thanks for the assistance!
From my installation, I click the Back link
Then I get this page
and click profile
now click profile again and scroll down that page to get here.
Its the same page where you would change your password, its your main VRM profile and should set preferences for every install you view.
I hope this gets you there ok.
The temp number is off in the VRM which appears the conversation is being done to second time
18C to 64.4F (or display in VRM just switches out the C to F)
Also I can't seem to get the Cerbo GX screen to display Fahrenheit
@BurntTech @Ur12VMan Thanks! This was a bug in the VRM portal and is now fixed
@Teun Lassche (Victron Energy Staff)
I now happily have my temperature set to ºF on the VRM Portal, but is there any way I can view it in ºF on the Touch 50 / Remote Console without having to do an offset and scale and (and still have a ºC next to the number)?
Really, I wish there was a page on the Touch 50 that would display the temperature readings (in ºF or ºC), like the forthcoming page for tank levels. Even better than that would be a fully customizable page that could include any of the available information and controls for connected gear. Am I missing how to do that or do I need to put this forward as a feature request?
@Ur12VMan you mentioned above " To change to F in VRM, click "back" in the VRM top left corner window until you see "profile" then click "profile" again, temp units is at the bottom of that page"
I cannot for the life of me find any "profile" - I get to installations...I see mine (plus another I viewed)...but this is killing me. I have the two temperature widgets enabled in Advanced (thanks for that! Totally non-obvious!) but while I can change the names on the VRM main page, changing from C to F has defeated me. Can you find this same place in the current VRM UI?
I tried looping in @m.cornforth and had a helluva time with that "@mcornforth"- finally...got a match on this with an embedded period...and I see that @Teun Lassche never responded...this does seem to be a perennial problem for us US-based folks but I won't take it personally, maybe they're targeting the Cayman Islands or Liberia who also use Fahrenheit. :)
