Just updated my MultiPlus 12/3000/120-16 from firmware 459 to 476.
According to the information I got from VEFlash, the update succeeds successfully.
But now absorption and float are flashing.
And get this notification on my Venus.
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Just updated my MultiPlus 12/3000/120-16 from firmware 459 to 476.
According to the information I got from VEFlash, the update succeeds successfully.
But now absorption and float are flashing.
And get this notification on my Venus.
Did you have an assistant loaded before the firmware update?
For example, I run an assistant which uses the temperature sense input as a signal from my BMS. After the firmware flash, the assistant is removed, the MultiPlus works as in factory settings and it gives me the same temperature sense error because then input is shorted by the BMS.
As soon as I re-load and run my assistant, the error goes away.
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
Additional resources still need to be added for this topic
Remotely Update VE.Direct Firmware
VictronConnect manual / Firmware updates
Updating a Victron Smart Solar MPPT Charge Controller with Victron Connect
VictronConnect configuration guide for VE.Bus products - Firmware Updates
27 People are following this question.