This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi I have a Multiplus 48/5000/70. I wanted to ask if it is possible to only charge the battery via the AC input and have the "AC-Out-1" and "AC-Out-2" off? I realized that the batter is charging in "on" and "charger only" mode, but in both modes the "AC-Out-1" and "AC-Out-2" are on as well.
Hi Not out of the box I’m afraid.
All I can suggest is you turn off the breakers on the output when you desire it.
you can programm this via Assistants
Hi Harold, how would you achieve this using assistance? I'm struggling to find the right one. Help appreciated.
Putting the Multiplus into "Charger Only" setting will still pass power to AC Output 1 if line power is available, AC Out 2 will be off. In "Off" setting, no power passes to either output. In the "On" setting, power goes to both outputs if Line power is available, and to AC Output 1 only if running on batteries alone. I had to check that to make sure!
I think it is possible to program a "safety switch" in the Assistants that can function like a kill switch for AC Output, and though I have not attempted this, it sounds like it may accomplish your goal. Make sure it is the last in the list of your Assistants, as it works through them in order. It could be deadly bad if a later Assistant turns the power back on. Tread carefully in the programming area!
As someone else noted, it's likely best, and easiest, to have output 1 and 2 going to breakers you can turn off when not needed. The breaker in the off position is a more "sight checkable" method to be sure the power is cut than relying on an Assistant.
