This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I had three multi-plus' connected in parallel, now obsolete, tried to run one of these in inverter mode with 25.6v battery bank inverter wont start, comes up with over the overload light on, but there is no load, battery bank is holding 25v + on solar panels charging at 28v any suggestions, can I do a factory reset manually, If so How? I have tried as below with no success
The unit will need to be reprogrammed as a stand alone unit before it can be run on its own. The overload is an error state.
Thank you for your answer Alexandra, Can I reprogram it to stand alone by the dip switches, I have tried setting them as dia in my first post third across, with no success, Is their some where I can get instructions to do this by the dip switches. or do I require the computer link.
You can do so through the dip switches. Their manual has all the information in them.
Manuals are available for download on their product page if you do not have the physical copy.
The computer link makes it easier if you know how to program them using it. Usually it is easier to upgrade the firmware and that wipes all past setting on the unit.
Thank you for your answer Alexandra, Can I reprogram it to stand alone by the dip switches, I have tried setting them as dia in my first post third across, with no results, Is their some where I can get instructions to do this by the dip switches.
