question

jnkelliott avatar image
jnkelliott asked

Quattro with Cerbo resetting every 24hrs

My 48/10000/140-2x100 Quattro (Firmware 430) is resetting every 24 hrs or so. It is on shorepower AC1, with the batteries SOC at 99% and set to UPS. There is no shore power disruption but the Quattro shuts down all power.

The only change in the system is, I switched from a CCGX to a Cerbo GX with a Color Touch 50 last week. The Cerbo is a rev01 with the latest Firmware 2.54. I also have a BVM-712 (firmware 4.03)

The Cerbo GX is also resetting at the same time.

The Quattro flashes 3x “bulk”, “absorption” and “float” alternating with “inverter on”. It then has a solid “float” led while flashing alternating 2x “absorption” and “inverter on”. It then repeats that full sequence multiple times until the Quattro restarts with “mains on” and “float” steady.

There are no assistants, no ESS, no BMS and the Virtual Switch is off.

Help!

MultiPlus Quattro Inverter Chargercerbo gxVE.Bus
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Daniël Boekel (Victron Energy Staff) avatar image
Daniël Boekel (Victron Energy Staff) answered ·

Hi @Jnkelliott

I'd first install the latest firmware, if the problem persists, we can look into it further. is the system connected to internet? if so, what is the VRM id?

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

jnkelliott avatar image
jnkelliott answered ·

The Cerbo is indicating that all of the firmware is up to date. Is there a newer version for either the Cerbo or Quattro?

Thr VRM is 020e04430330

Thank you!

6 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Daniël Boekel (Victron Energy Staff) avatar image Daniël Boekel (Victron Energy Staff) ♦♦ commented ·

Hi @Jnkelliott

I see an error 14:

https://www.victronenergy.com/live/ve.bus:ve.bus_error_codes#error_14_-_device_cannot_transmit_data


I'd first check your cabling (just use a new rj45 cable temporarily instead of existing cable)

Also check if there is not accidentally a ve.CAN terminator used on the ve.BUS connectors (the blue connectors without a cable attached) ve.bus doesn't use terminators.

for the Quattro there is a newer firmware available yes:

https://docs.victronenergy.com/victronconnect-vebus.html#firmware-updates

0 Likes 0 ·
Show more comments