This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
How does the Orion-Tr Smart DC-DC work with the new vehicles that have 5 or 6 different charging profiles. For the most part if the battery is topped off the charging system cuts back to 13.6 volts. If you are charging LiFePO4 batteries that require 14.4 volts how does it do that when charging system is at 13.6 volts?
Greg
@LanduytG, like all reputable DC-DC chargers with which I'm familiar, the Orion-Tr Smart has a buck/boost converter inside to allow it to step up or down the input voltage (within limits) so that it can correctly output the appropriate voltage as programmed.
well in case it does not do that
Hello
i have install today the new Dc-Dc isolated 30 amp
here's my setup
Truck battery - guage2 wire 25' - breaker 80amp - , gauge 8 wire 2 ' - battelborn 2x100
i purchase this unit to increase the voltage and have 30 amp to recharge the Battleborn
Lipo battery need more than 13.6 to charge
so far i was not able to get good voltage on the camper batteries
- the Bluetooth signal is not good. Compare to my other unit (all at the same place)
- what setting should be done to get higher voltage?
example
truck alternator is at 14.5
output is a 13.3
