I just updated a SmartSolar MPPT 100/30 to firmware 1.49 using VictronConnect v5.21beta5 (iOS TestPilot says beta 5 but settings shows beta 4), the solar harvest starts fluctuating and also the DC voltage starts to show some disruption. The output will slowly increase and then suddenly drop to 0 after which it starts up again slowly. It would continue this cycle until the sun is down.
After the update, VenusGX showed a notification that there was an unsupported DVCC firmware so I updated the connected Phoenix MultiPlus 800 to FW 474. I also updated the ESS assistant. I have restarted every single component in the system, disabled DVCC to no avail. Eventually I removed the load and disabled feeding back into the grid to safeguard the battery because this was the only thing I could do to stop the DC voltage fluctuation.
I also have a BMV700 in the system which is already running latest firmware.
I did do a factory reset for the SmartSolar MPPT to no avail. Could something have gone wrong during the firmware update? It halted for a few second during the update process and then started over. Is there a possibility of downgrading the MPPT to a slightly older Firmware just to check?
This system had a perfect was working perfectly before, there were also no clouds in the sky that could explain the behavior.