This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Had to disconnect my solar charger to uninstall a breaker. Now it's not charging the batteries. All wiring is correct. Open circuit voltage of panels is above 19 until I plug them back in, then it drops to 13 or so. Charge state says off.... What did I do. 12 volt lifepo4 system. 400ah. Mppt 100/50 and bmv-712
@Lokiperformance1 Always start with what exactly has changed? Did you disconnect it under load? Was the breaker serving the panels? Did you reverse polarity? Did you first connect the battery, then panels when reconnecting? Try disconnect everything and leave for a bit to see if it recovers. Are the settings still correct and what is the state of charge of the battery? Is it a blue or smart solar? Good luck with your fault finding.
The order in which I proceeded is as follows. I disconnected solar, then the batteries, then I uninstalled the main breaker to batteries as it was faulty, I reconnected power to inverter and charger lastly I reconnected solar. It was done at night so I didn't realize it wasn't charging via panels until the next day. I've been through all the simple things. I've reset and reconfigured the system two or three times now. I am now proceeding to bash my head on the brick wall untill the issue is resolved.
Beating my head against the wall worked. I installed some backup fuses in my panels. It must have surged the system or something when I hooked it back up. Thanks for your input though.
