question

david-stone avatar image
david-stone asked

Load output turns off when I connect something

Hey there,

I've got the MPPT 75/15 and the Load output turns off once I connect my 12v laptop charger. Other charger for a different laptop works... I recently switched from a Lithium ion Battery to a lead starter battery... it worked before... I've tested the charger to see if its broken but seams to work just fine. When I connect the charger to the MPPT it turns the complete output off and I see the Laptop charger LED pulsing like the MPPT is testing If its still connected.. When I connect an inverter the MPPT shuts down for a few seconds and then back on.

So it seams when there is a high load/short the MPPT shuts down. But it does it with the charger even if no laptop is connected.

Thanks in advance

MPPT Controllers
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
rossasaurus avatar image
rossasaurus answered ·

I'm having a similar issue with a SS 100/20 24V system.

What was your system battery voltage, do you know?
Victron App will show your lowest Battery voltage for each day.

I suspect my battery was too low of voltage(25.3V, though above load cutout spec of 23.6V) and when a 2nd fan(the load) switched on, the Load Output dropped completely.

It seems to have recovered, though battery voltage is only marginally higher than before.

I will likely convert to a BatteryProtect to run the fans instead of the MPPT Load Output terminals.

Oh, Looking at the Spec sheet again, I now see under 'Low Voltage Load Disconnect', "Battery Life Algorithm", so I'm guessing this means the Load Disconnect Voltage is not fixed, but varies according to the algorithm, since I do have "Battery Life Algorithm" chosen in my settings.

Spec Sheet for 75/15 & 100/20:
https://documents.wholesalesolar.com/media/specs-20190820213111.2940150-2.pdf

It would be useful to be able to view the cutoff voltage the algorithm is choosing, otherwise I think it's an equipment issue not meeting spec.

Much to learn!


Good Luck David

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

david-stone avatar image david-stone commented ·

Hey thanks for your answer!

it seams like its not a problem with low voltage.. I now have a new 110ah battery connected and the problem remains.. Battery is fully charged and im getting solar energy..

Also happen when output is set to always on..

Still when I connect that 60w charger it turns off instantly.. That doesn't happen with another charger wich takes 90W...

Also my inverter worked fine all the time and now decided to trigger that exact same problem...

Cheers

0 Likes 0 ·
Show more comments