This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
HI i have two victron 250/100 tr mppt's. i recently did a firmware update to version 1,47 and one of the mppts are ramping the solar wattage up and back down again but when you test on the fuses the voltage and amperage stays constant.
is there a way to roll back a software to one version prior and reload the new version? because the MPPT was working fine before the upgrade.
your help is much appreciated
Similar problem with new firmware and solution is here : https://community.victronenergy.com/questions/46276/smart-solar-250-100-rev-2-firmware-146-dup-file.html
Hi Nathan
Had the same problem. It's not a firmware update problem. Check on the victron app if u not accidentally created a VE. networking network. There should be no VE network.
