This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I am currently running firmware 2.50 on a new Cerbo Gx. I have tried to update firmware by usb stick , and micro Sd card. The system briefly shows a message to say firmware present on stick or SDcard but then will not proceed to install.
Firmware filename I think is venus-swu-beaglebone.swu
can anyone assist?
Hi @DrW,
The Cerbo GX uses the swu-einstein firmware file, not beaglebone.
The current version is posted here - venus-swu-einstein.swu
I have the same issue with a Venus GX, can you please advise whether I have the correct swu file?
Current version 2.18. New version 2.57. File name “venus-swu-beaglebone.swu”.
For info I have no Ethernet and connect to the Venus over WiFi on an Android phone. The phone gives me the option “press to update”, after which the phone says “updating” for 12 seconds, then it reverts to “press to update”. After this, pressing the “update” button causes the screen to change to “updating” for just ~2 seconds before reverting to “press to update”.
Do you have internet via LAN or WLAN available? That would be the easiest way.
Sadly not at present. We do have a network on board, and the Cerbo is both wired to the router and connected by wifi - but due to the coronavirus the shipyard we are currently berthed in has closed down and internet is 'off'
I have tried to hotspot my phone to the cerbo but reception poor.
Can anyone confirm the firmware file name for cerbo gx please
Quick question to add to this if I may?
The software files show two version Beaglebone and Einstein, what is the difference?
I have googled and searched to no avail and have not found a real answer anywhere.
Assumption is that Einstein is for the Cerbo GX and Beaglebone for the Venus.
Correct!
There is a reference here in Cerbo GX manual for Venus GX.
