Good morning!
Per just now a new version of Venus OS is available to test as a Release Candidate.
This will be a short cycle: first test version released just now, I expect another one later this week, and then when all is as it should be, official release next week.
Three changes:
- Fix bug affecting our new generation of VE.Can SmartSolar Chargers in systems with a CAN-bus BMS: the maximum charge current limit wasn't always sent properly to those devices when connected using a VE.Can network. When connected on VE.Direct, everything did and still does work properly. There is a related issue in the Solar charger firmware itself, for which we'll make a release shortly. The practical effect on most systems is small or even negligible, since all control of charging, also when a battery is full, is done using voltage limits. Not charge current limits.
With both fixes in places (this one, and the one in the VE.Can SmartSolar Charger firmware), the chargers will be autoconfigured to BMS-Controlled again, as they should be. - Change handling of Sony aka Murata managed CAN-bus BMS batteries.
- Minor bug fix: the Cerbo GX was not recognised in the VRM Portal. It showed "Generic Venus Device"; not any more.
All the best, stay safe in these weird times and I'll be monitoring the comments below for your findings.
Matthijs Vader
ps. If you don't know what this post is about: this is about our GX Product range (CCGX, Venus GX, Cerbo GX, and so forth). This message is for all the members of the Beta test group. Information on how to join (and leave) that group.
