Hi, I have the following configuration:
- Victron MP2 5000 / 70amp charger
- SMA 5000TL-21 solar inverter on AC-Out#1
- Pylontech US3000 batteries
- Color Controller
If I have to turn the SMA inverter off and then turn it back on later, the CC display looks like this (still) after 15 minutes from turning on the SMA Inverter:
You can see that the Solar inverter is working because it is exporting, however:
- SMA inverter is not shown,
- AC Loads are not registering (=0) despite being around 600W.
The SMA is remembered:
But does not appear on the device list:
This has happened a few times and it often takes hours before the display corrects itself.
I was running FW 2.51 on the CC but saw that 2.52 was available, so I installed that, but alas, still the same problem.
The CC and SMA are both on the same subnet and I can confirm that the SMA has obtained its IP address which is fixed by DHCP settings. I can confirm this by the SMA front panel.
Is this a known issue?
thanks for your assistance,
Ron