This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi, I'm looking to add another 12/2000/80 to my setup to increase my output wattage in order to remove propane and add induction hob and convection oven, but not sure if I can as I have used both the RJ45 ports on what would be the master Multiplus, so nothing left to connect to what would be the slave Multiplus. Will I just have to sell the 12/200/80 and get a 12/3000/120 Multiplus?
Hope someone can think of something I haven't...
Mike
the second multiple will give you another two ports. You just daisy chain MP1 to MP2 then to the Venus. With two multipluses, you end up with two free ports after they are chained together.
make sure you get identical units (and running same firmware) when trying to parallel or split phase two inverters together.
Ah, I thought that I would have to connect the Venus and VE.bus BMS to the master multiplus. So I'll connect the 2 MP's together, connect the VE.bus BMS to the master and the Venus to the spare port on the slave MP right? Thanks for the tip on firmware - will make sure!
