This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
hi,
just updatet victron connect to 5.19 and wondering why my mppt 100/50 firmware is not as well updated
currently i have 1.46 firmware and when i chose firmware update on connect 5.19 it says that i am up to date
however i can see online that there is 1.47 firmware for mppt 100/50
could someone please help
thank you
vladi
@vladi and @ThomasSolar, MPPT FW version 1.47 is currently only available through VRM update or manual load-in; this is deliberate, not an error within the VC application. When FW version 1.47 is approved for general release and included within VictronConnect, there will be an announcement from Victron that both announces the release as well as outlines the added features contained within it.
any idea when will this happen and what would be improved?
does one info page exists, about development?
like for VC https://www.victronenergy.com/live/victronconnect:beta
thank you fo your answer
I have experienced the same. I had to download FW v1.47 and install it «manually». Even if 1.47 wad released months ago, it has not been installed automaticly just by updating Victron Connect.
I have the 150/100rev2 charge controller and also updated to V1.47 through VRM. But now when you look at the CCGX, the Solar PV yield rises and the drops to 0W and goes through this cycle constantly. I need to roll it back to the previous v1.46.
